In this blog, one of our Filter Belt technical experts discusses important tips for properly breaking in new belts on your belt filter press. These guidelines are best applied to municipal wastewater treatment but are useful for all belt press filter applications including for industrial waste, mining, food & beverage, and more. Properly breaking in your new filter belts can increase press belt life and prevent premature belt failures. Learn more below.
Six Tips for Properly Breaking In Your New Belt Press Filter Belt
A new filter belt should always be broken in at low speeds for about 1 – 2 hours before being loaded with sludge. This ensures that the new belt will track properly into position. Following this belt conditioning procedure will help prevent wrinkles on a newly installed belt.
The machine should be monitored closely during the break-in period. Sludge should not be introduced to the machine until the break-in period has been completed.
The Micronics Engineered Filtration Group recommends that you follow these 6 steps to properly break-in a new belt press belt.
- Properly adjust the tensioning pressure on both pressure dewatering belts.
- Start the belt wash water flow and energize the belt drive. Use warm water if available.
- Increase the belt tension during the break-in cycle. Refer to the following chart for suggested belt tension. Consult your equipment operator’s manual as equipment may vary.
| Time Period | Belt Tension (pounds per linear inch) |
| First hour | 30 pli |
| Second hour | 40 pli |
| Third hour | 50 pli |
| Fourth hour | 40 pli |
- Set the belt tension to the desired setting for running the process stream. Generally, both belts will be operated at the same pli setting, not the same hydraulic pressure (psi).
- After the break-in procedure is completed, readjust to the proper operating settings. Note: Fine adjustment of the steering circuit is best done with the belts moving.
- Check and readjust after the first week of operation. Running at higher tensions will create a drier cake while running at lower tensions will promote longer belt life.
Always use extreme caution when working around the moving belt. Avoid loose clothing that might become caught in the belt.
Properly breaking in new belts on your belt filter press can increase life and prevent premature belt failures.
The Micronics Engineered Filtration Group has the products, services, and expertise to help with your belt filter press needs.
Contact Us today to get in touch with a belt press expert.
Contact Our Experts
Micronics Is Your Trusted Partner for Total Engineered Filtration Solutions. We offer end-to-end solutions from Filter Media to Industry-Leading Filtration Equipment, to Spare Parts & Accessories, to On-Site Field Services and In-House Laboratory Services. Whether for your Filter Press, Belt Press, Leaf Filter, Vacuum Filter, or Baghouse, you can count on Micronics’ deep industry and applications knowledge for the right engineered filtration solution to meet your needs. We look forward to working with your team.